Posts Tagged ‘360’

Project: Fightstick (Part 2)

March 5, 2009

My joystick and small buttons arrived yesterday (action buttons will arrive next week) so I made a start on creating the fightstick. I cut out three layers for the face of the box. The top layer is made from plexiglass with holes for the buttons and joystick shaft. The next layer made of 3mm plywood has the holes for the buttons, and a rectangle cut out for the joystick plate. Then the third layer of 8mm wood has a smaller hole for the joystick box, allowing the plate to be screwed to it, and a large hole cut out around the buttons to allow access to screw the buttons to the other layers.

I’m quite pleased with the way it’s turning out so far, considering I have no experience in woodworking whatsoever. The wood isn’t cut extremely well, but this wont be seen when the artwork and plexi is on top. My biggest disappointment was the plexi glass has some cracks between the buttons, but this should be mostly covered by the button tops. I have another piece of plexi, so might take another go with that.

Tonight Jamie and I start soldering the electronics.

Photos speak a thousand words…


(After taking this photo I cut the rectangle out for the joystick plate)


Printed the artwork for the face, which will sit under the plexiglass.

Project: Fightstick (Part 1)

February 23, 2009

Last week marked the release of Street Fighter IV on consoles. I’ve always fancied an arcade joystick, really the best way to play such fighting games. Unfortunately I missed out on getting my hands on one of the very limited SFIV sticks (currently being sold on eBay for £200-£550!!). Looking around on the net I discovered lots of people have built their own joystick, and taking inspiration from some stunning examples, I’ve decided to design and make my own.

Put simply, creating the stick breaks down into…

  • Stripping the PCM board out an old controller
  • Building a box from wood and plexiglass, with holes for the buttons and joystick
  • Soldering wires between the PCM board and the buttons

I have enlisted the help of my friend, an electrical engineer, for the soldering and my brother is keen to help build the box (unfortunately he lives in Australia!). I have ordered the following parts from Gremlin Solutions. They are high quality arcade parts from one of the best manufacturers in the world, Sanwa..

  • 6 x OBSN-30 (White) for Punch/Kick Buttons
  • 3 x OBSN-24 (Blue) for Start/Select/360 Guide
  • 1 x JLW-TM-8 (White ball top) Joystick

Parts are going to take a week or two to arrive. Meanwhile I am designing the box in Adobe Illustrator, and working out the best layout for the buttons.